Sometimes an imagesetter cannot interpret image clipping paths, or an image clipping path is too complex for a printer, resulting in a Limitcheck error or a general PostScript error. Sometimes you can print a complex path on a low-resolution printer without difficulty but run into problems when printing the same path on a high-resolution printer. This is because the lower-resolution printer simplifies the path, using fewer line segments to describe curves than the high-resolution printer does.

You can simplify an image clipping path in the following ways:

• Manually reduce the number of anchor points on the path.

• Increase the tolerance setting used to create the path. To do this, load the existing path as a selection, choose Make Work Path from the Paths palette menu, and increase the tolerance setting (4 to 6 pixels is a good starting value). Then re-create the image clipping path.